5 typical water softener problems you might run into

People can rely on water softeners to purify and filter their home or business water supply. However, they are not that perfect. On certain occasions, some of them will find a fault or some kind of malfunction.

To ensure that their model is always efficient, owners must monitor it closely. However, what do they need to keep in mind in particular to ensure that you are always performing at your full potential? Here are 5 common problems related to these products that you may run into:

Clogs

One of the typical water softener problems that you will occasionally experience is clogging or blockage.

Blockages are usually caused by a build-up of salt and other minerals inside the fabric softener. When these minerals have built up to a certain point, there is less room for the water to run.

Such clogs will lead to water that doesn’t feel as soft as it used to and works more like hard water. Fortunately, most obstructions are easy to repair.

Engine faults

Like anything that runs on engines, water softeners are susceptible to engine failure. Although this problem is not something that is normally encountered by a milder, it is still a problem that people should be aware of.

In order for a softener’s motor to last as long as possible, it is essential that it undergoes regular maintenance. This means that you need regular cleaning, filter change and emptying, among other responsibilities.

Defunct resin beads

A salt-based water softener uses resin beads. These accounts are necessary for a salt-powered model to function properly. In essence, resin beads replace hard minerals with soft minerals.

The resin beads in water softeners are made to last as long as the life of the product, but sometimes they don’t last as long.

When the resin beads no longer work, they are seen floating in the water in the softener. In many cases, they must be replaced in their entirety.

Salt bridges

There are some cases where the brine tank of a water softener will be covered with a hard, crusty material that prevents the water from flowing. This hard, crunchy material is due to high humidity or the addition of a lot of salt to it.

Salt bridge, as this hard, crunchy material is called, will prevent a water softener from using salt and as a result will prevent it from softening the water.

Some people may try to break the salt bridge by pressing a long stick hard into the water softener, but it would be best to enlist the services of a professional. In this way, they can be sure that the mechanical system of the softener will not be damaged.

Dirty filter

A dirty filter is one of the most common problems with water softeners that people can encounter.

At the beginning of the water filtration process, these products use filters to prevent the entry of large minerals. For this reason, of all the components, these filters encounter a large amount of sediment.

For a water softener to perform to its full potential, it is recommended to change its filter once every 3 to 5 months. Unsurprisingly, in case there are problems even before this, there are reasons enough to change it immediately.